RTU
CHIP BACK STYLE and CHIP FORWARD STYLE
14.51-65.00mm SINGLE TUBE SYSTEM
RTU heads are ID threaded and will fit all single start drill tubes. Under favorable cutting conditions, an excellent hole quality is obtained. Cutting edge may be reground several times before discarding head. Instructions available upon request. Supplied with standard chip-breaker dimension unless otherwise specified. Chip foward reamers are used for through hole only. Chip back reamers can used for both blind and through hole reaming. In reaming though holes, the exit end of the part must be sealed off.
RBTU
CHIP BACK STYLE and CHIP FORWARD STYLE
18.51-65.00mm SINGLE TUBE SYSTEM
RBTU heads are OD threaded and will fit all four start dill tubes. Under favorable cutting conditions, an excellent hole quality is obtained. Cutting edge may be reground several times before discarding head. Instructions available upon request. Supplied with standard chip-breaker dimension unless otherwise specified. Chip foward reamers are used for through hole only. Chip back reamers can used for both blind and through hole reaming. In reaming though holes, the exit end of the part must be sealed off.
RETU
CHIP BACK STYLE and CHIP FORWARD STYLE
18.91-65.00mm SINGLE TUBE SYSTEM
RETU heads are OD threaded and will fit all four start drill tubes. Under favorable cutting conditions, an excellent hole quality is obtained. Cutting edge may be reground several times before discarding head. Instructions available upon request. Supplied with standard chip-breaker dimension unless otherwise specified. Chip foward reamers are used for through hole only. Chip back reamers can used for both blind and through hole reaming. In reaming though holes, the exit end of the part must be sealed off.
COUNTER BORING & REAMING HEAD
IKUSTRxxE OUTER FOUR START THREAD 25.00-99.99
KUSTRxx INNER SINGLE START THREAD 25.00-110.99
LARGER SIZE AVAILABLE UPON REQUEST
COUNTER BORING HEAD
USTCXX-25.00-329.99
COUNTER REAMING HEAD
UTCRXX-XX.XX 44.00-233.99mm
Counter Reaming Head is used to bore up an existing hole. when a close tolerance is required , the head may be used as a reamer by replacing the outer cartridge with the OX style cartridge.